I'm having trouble finding my VELUX products during the installation. What should I do?

Using a remote control with display:

1. Check that all products known by the controller can be operated from the point where the gateway is positioned. 
   • If you receive a "no contact" feedback, try to move closer to the product and try again -  when success then move the gateway to this position.
   • If you receive a "wrong security key", check the controller instructions on how to achieve a new and valid security key.
2. Check if you have a "master" control for the entire home or individual room controls.
   • If you have a "master control" then always use this for the product registration
   • If you have individual room controls, start adding the products of the first controller to your ACTIVE and finish the setup with these products only. To add the remaining products go to: Settings>Install new products>Install a new window>Next and follow the in-app instructions. Note: The remote control instructions are slightly different as you are now aligning the security keys during the process.
3. Check if you have selected the correct control option in the app (uni-directional controls are found by pressing the button "I don't have those remotes").
4. Try closing down the app and re-open it to see if you have an unfinished installation. If so, then finish the installation.
   

Using a wall switch without feedback (uni-directional) OR a combination of controls (uni- and bi-directional):

1. Check if you have any bi-directional remote control paired to your products. If so, use this when adding the products to the gateway (see above).
2. Check that all products known by the wall switch can be operated from the point where the gateway is positioned. 
   • If you can't control the products, try to move closer to the product and try again - when success then move the gateway to this position. 
   • Otherwise, check the controller instructions on how to pair the wall switch to the product.
3. Check if the product is moving back and forth to indicate registration is ready, when pressing the gear button (on older controls the reset button) on the wall switch. 
   • If the product isn't moving, try once again to press the gear (old controls the reset) button on the wall switch.
4. Check if you have selected the correct control option in the app (uni-directional controls are found by pressing the button "I don't have those remotes").
5. Try closing down the app and re-open it to see if you have an unfinished installation. If so, then finish the installation.