Roller Shutter - High Level Configuration (KLR 200)

High level configuration should only be carried out if the product, is not stopping to its chosen position.

Step 1

Remove the end cover cap.

Left-hand side when viewed from the outside.

Step 2

Set switch to position O (off).

Wait 30 seconds then turn back to the I (on), position.

Step 3

Scroll through the remote control until you locate the roller shutter.

Step 4

Select the roller shutter on the remote, and press the STOP icon, immediately followed by the CLOSE icon.

Step 5

Once the blind has reached the bottom of the window, then operate the blind as normal.

Step 6

Replace plastic cover

The motor must be adjusted to the size of the window before full operation of the roller shutter begins. The adjustment will take place automatically the first time the roller shutter is operated. Before the roller shutter runs to the preferred position, it runs all the way up and down.

Do not interrupt the adjustment!

Was this answer useful?
Yes No

Need more help?